Oki ES9160, Руководство по обслуживанию

Страница: 425 / 1087

6
© 2012 OKI DATA CORPORATION All rights reserved ES9160 MFP / ES9170 MFP
SETTING / ADJUSTMENT
6 - 117
[B] Punch waste full sensor output adjustment
(1) Turn OFF the power of the equipment.
(2) Take off the rear cover of the finisher.
(3) Confirm that the punch waste case is installed correctly and also no punch waste exists in the
case.
(4) Set the bits 1, 2 and 3 of the DIP switch [2] on the hole punch control PC board (HP) [1] to ON.
Then turn ON the power of the equipment while pressing the pushbutton switch [3] on the hole
punch control PC board (HP) [1] and the digital keys [0] and [8] on the control panel of the
equipment.
Fig.6-134
(5) Set the bits 1, 2, 3 and 4 of the DIP switch [2] as shown in the table below.
(6) Sensor output is adjusted automatically by pressing the pushbutton switch [3].
LEDs [4] on the hole punch control PC board (HP) [1] start blinking as the adjustment is started.
When the adjustment is completed, the LEDs [4] are lit.
(7) Turn OFF all bits of the DIP switch [2].
(8) Install the rear cover of the finisher.
Target sensor
DIP switch
1 2 3 4
Punch waste full sensors OFF OFF OFF ON
[1]
[2]
[3]
1 2 3 4
ON
CPU
LED
[4]