Ness D24, Инструкция по установке и программированию

Страница: 51 / 60

51
neSS D24 Control Panel - inStallation & PrograMMing Manual
OPEraTiNg THE d24 by TElEPHONE
rEmOTE OPEraTiON by TElEPHONE
the D24 control panel will allow a
user to call in to the panel, using
a standard DtMF telephone, and
remotely arm or Disarm all areas and
also turn on or off aux 1 and aux 2.
to maintain panel security, remote
operations can only be carried out
after entering a valid user code.
to operate the panel by telephone,
you need a DtMF capable telephone,
a valid user Code and you must
know the telephone number of the
line to which the panel is connected.
nOtes
1. if the D24 does not receive
commands for periods longer than
10 seconds it will assume that the
call is finished and it will hang up.
2. you can keep the panel on line by
regularly pressing the button on
the telephone.
3. if an alarm occurs which requires
the D24 to dial out, the D24 will
treat the alarm as a priority, give
a constant tone as a warning and
then hang up. it will then pick up
the line again to report the alarm as
programmed.
4. When all remote control
commands are finished press
to force the D24 to hang up.
telephOne COMMands
Prepare to receive commands
Arm the panel*
Arm Area 1
Arm Area 2
Arm Area 3
Turn Aux 1 Output ON or OFF
Turn Aux 2 Output ON or OFF
9 9 # Disarm all Areas
Finished - hang up
audIBle FeedBaCK
3 BEEPS:
• The User Code is valid
• Successful Arming or Disarming
• An Auxiliary output has been turned ON.
1 LONG BEEP:
• The panel is already Armed
• Invalid code. Try again.
1 SHORT BEEP:
• An Auxiliary output has been turned OFF.
related OptIOns:
p58e 3e Enable remote ADMIN. Arm
p58e 4e Enable remote AREA 1 Arm
p58e 5e Enable remote AREA 2 Arm
p58e 6e Enable remote AREA 3 Arm
p58e 7e Enable remote AUx1, AUx2
p58e 8e Enable remote Disarm all Areas
OperatIOn.
1. Phone the D24 telephone number
and listen for the required number
of rings (ring ring...ring ring) and
then hang up. (Default is 1 ring).
2. Call the number again within 60
seconds.
3. the D24 will answer the second
call immediately, sound a beep for
2 seconds then, after a pause, it
will sound a lower frequency tone.
the panel is now ready to receive
telephone commands.
4. Press the button on the
telephone. this tells the D24 that
telephone commands will follow.
the D24 will respond with either 3
beeps if all oK or one long beep to
try again.
5. now enter a valid user Code
followed by the button. (use
a code that is normally used for
arming or Disarming the D24).
the D24 will respond with 3 beeps
if it recognises the code or 1 long
beep to signal the code was invalid
and to try again.
6. enter the required command.
See: Summary of telephone
Commands.
7. Press to finish. this tells the
D24 to hang up. also hang up your
telephone.
* The 0E command arms the Admin Area. This
means, if there are no areas programmed,
it arms the whole panel. If areas have been
programmed, 0E arms any zones that remain
in the Admin area, (i.e. zones that have not
been allocated to any area).