Ness D24, Инструкция по установке и программированию

Страница: 21 / 60

21
P r O g r a m m i N g
Prog
neSS D24 Control Panel - inStallation & PrograMMing Manual
ON
ON
OPTION No DESCRIPTION DEFAULT
P34E
MISC. SYSTEM OPTIONS
Keyswitch unrestricted operation 1E
Chirp siren on K/S Arm/Disarm 2E
Disable Auto-exclude
Entry beeps
Disable zone tamper
Aux1 Armed output
Zone unsealed warning on Arming
3E
4E
5E
6E
7E
8E
miSC. SySTEm OPTiONS
P34e 1e keYSWItCH UNreStrICteD oPerAtIoN.
oFF: a delay zone must be activated before operating the keyswitch otherwise an
alarm will occur.
on: the keyswitch operates at all times.
P34e 2e CHIrP SIreN oN k/S Arm/DISArm.
Selects Siren Chirp when arming/Disarming by Keyswitch or radio Key.
they Key input must first be enabled as a keyswitch input
oFF: no siren chirp.
on: Siren chirp on arm/Disarm enabled.
SIreN CHIrPS
arMing: one chirp from Siren B.
DiSarM: two chirps from Siren B.
P34e 3e DISAbLe AUto-exCLUDe.
oFF: auto-exclude is enabled. Zones unsealed at time of arming are automatically
excluded at the end of exit delay.
on: auto-exclude is disabled. Zones unsealed at time of arming will activate the
alarm at the end of exit delay.
P34e 4e eNtrY beePS.
oFF: no entry Beeps.
on: Keypad beeps during entry delay time.
P34e 5e [not used]
P34e 6e DISAbLe ZoNe tAmPer.
When Zone tamper is enabled, the zones are sealed with two 4K7 resistors which
allow monitoring of both alarm and tamper in each zone input over 4 wires. See
page 7 for connection examples. Zone tamper is disabled by default.
Zone tamper looks for these resistances:
Zone Sealed: 2K2, Zone alarm: 4K7, tamper alarm: open circuit
oFF: Zone tamper enabled.
on: Zone tamper disabled.
Zone Tamper is available in D24 V1.2 and later.
P34e 7e AUx1 ArmeD oUtPUt.
oFF: aux1 not affected by arming.
on: aux1 follows panel arm/Disarm state.
P34e 8e ZoNe UNSeALeD WArNINg oN ArmINg.
oFF: no zone unsealed warning.
on: the reSet output will sound a 2 second alarm immediately on arming if
arming with a zone unsealed.
P34e, 1e–8e
prOgraM MOde leVel:
Installer, Remote by PC
FaCtOrY deFault:
[see table]
tO prOgraM:
p 34 e [Option] e
Toggles the option ON and OFF.
nOtes:
SIREN CHIRP: By default, the KEY input is a
Panic input.
to use the KeY input as a keyswitch
input, program p400e 1e , (this maps the input to
Output Group zero, which disables it as a zone).
related OptIOns:
P40xxE 1E: Mapping Keyswitch Panic (KEY input)
to Output Groups, page 23.