Meco Pellematic PES 12-20, Руководство по установке

Страница: 20 / 102

Bringing the pellet boiler into the boiler room
20
7
Bringing the pellet boiler into the boiler room
This section describes the prerequisites as well as the working sequence required.
1. Transport
2. Notes on bringing the unit into the building
3. Casing parts
4. Dismantling the casing parts
7.1 Transport
MEco supplies the pellet boiler on a pallet. The pellet boiler is ready to be connected up.
The control unit for the boiler controller and the operating drvice is integrated into the control panel.
The ash box and the optional external ash box with de-ashing system and the flue tube connections are supplied in
separate packages. These need to be installed on-site.
If it is not possible to bring the boiler into the building at ground level, then you can remove the casing, the burner, the
hopper and the boiler controller. This will reduce the weight of the unit and make it easier to carry.
Contamination and corrosion
Make sure that the pellet boiler is located under a roof if it
needs to be stored outside before it is transported/brought
into the building.
7.2 Notes on bringing the unit into the building
Before bringing the unit into the building, check the dimensions of all doors to ensure that the boiler has sufficient
clearance and can be set up properly.
Minimum door width — max. unit dimension
PE, PES 12, 15, 20 27 1/2 inch
PE, PES
25, 32
29 3/4 inch
PES 36, 48, 56 31 1/8 inch
Boiler dimensions
Installation Manual PES 36–56 PE 3671 USA 2.3