HEADER – GENERAL
169469/169470/169471
96
Revision E
2. If the header is below the pre-set height, press
and hold the HEADER UP switch to raise the
header. Release switch to stop header.
Alarm will sound when header rises past the
pre-set height.
3. If the header angle is changed, double click
(two clicks within 0.5 seconds) the HEADER
TILT UP or HEADER TILT DOWN switch, and
the header will return to the pre-set angle.
NOTE
If the header cannot return to the pre-set
height or angle within 30 seconds, the
RETURN TO CUT feature will deactivate to
prevent the hydraulic oil from overheating.
Push the RETURN TO CUT switch to
reactivate.
6.4.6.2 Auto-Raise
Height
a. Program the AUTO RAISE HEIGHT feature as
follows:
1. Press PROGRAM and SELECT on Cab
Display Module (CDM) to enter programming
mode.
2. Press SELECT. TRACTOR SETUP? is
displayed on upper line.
3. Press , then SELECT. SET KNIFE
SPEED? is displayed.
4. Press SELECT until AUTO RAISE HEIGHT is
displayed.
5. Press or to change value on
lower line. Working range is 4.0 to 9.5. OFF
disables the feature.
6. Press PROGRAM to exit programming mode
when finished entering desired values.
b. Use the AUTO RAISE HEIGHT feature as follows:
IMPORTANT
The windrower must be running with the
header engaged at the cutting height and
the RETURN TO CUT switch activated.
1. Double click HEADER UP switch on the
Ground Speed Lever (GSL) to raise the
header to the AUTO RAISE HEIGHT set
point.
NOTE
If HEADER UP is pressed while header is
being raised, AUTO RAISE HEIGHT is
temporarily disabled and header will
maintain current height.
NOTE
With AUTO RAISE HEIGHT off, the ACRE
counter will be disabled when header height
value is >9.5. OFF is displayed on the CDM.
2. Momentarily press the HEADER DOWN
switch on the GSL to return the header to the
pre-set cutting height.
6.4.6.3
Header Drop Rate
The header should lower gradually when the
HEADER DOWN switch is pressed. From full
height to ground should take approximately
3.5 seconds. If the drop rate requires adjustment,
refer to Section 7.11.5.3 Header Drop Rate.
HEADER DOWN
RETURN TO
CUT
DISPLAY
HEADER UP
Содержание M205 2012
