HEADER – GENERAL
169469/169470/169471
87
Revision E
6.4 HEADER
OPERATION
The M205 Windrower is designed to use the
MacDon A-Series auger header, R-Series rotary
header, and D-Series rigid draper header, with or
without a hay conditioner. This section describes
the attachment and detachment procedures and
operating instructions for these header types.
6.4.1
HEADER LIFT CYLINDER STOPS
Cylinder stops are located on both header lift
cylinders on the windrower. To avoid bodily injury
or death from fall of raised header, always engage
cylinder stops before going under header for any
reason. Engage cylinder stops as follows:
a. Press HEADER UP switch to raise header to
maximum height.
NOTE
If one end of the header does not raise fully,
the lift cylinders require re-phasing.
Proceed as follows:
1. Press and hold the HEADER UP switch until
both cylinders stop moving.
2. Continue to hold the switch for 3–4 seconds.
3. Cylinders are phased.
b. Pull lever (A), and rotate toward header to release
and lower cylinder stop (B) onto cylinder. Repeat
for both lift cylinders.
c. To store, turn lever (A) away from header to raise
stop until lever locks into vertical position.
B
A
HEADER UP
HEADER DOWN
Содержание M205 2012
