WINDROWER OPERATION
169469/169470/169471
65
Revision E
g. Normal Start – engine temperature above 60°F
(16°C):
1. Set throttle (D) to START position – fully back.
IMPORTANT
The machine gauges and instruments
provide important information about
machine operation and condition.
Familiarize yourself with the gauges and
monitor them carefully during start-up
operation. Refer to Section 5.15 ENGINE
CONTROLS/GAUGES.
CAUTION
Be sure the area is clear of other persons, pets
etc. before proceeding.
2. Sound horn three times.
3. Turn ignition key (E) to
RUN
position.
4. Single loud tone sounds, engine warning
lights illuminate, and Cab Display Module
(CDM) displays HDR DISENGAGED or
HEADER ENGAGED and IN PARK.
5. Turn ignition key to
START
position until
engine starts, and then release key. Tone
ceases, and warning lights go out. CDM
displays programmed header data for
5 seconds if attached, and then returns to
previous display.
IMPORTANT
Do not operate starter for longer than
15 seconds at a time. If engine does not
start, wait at least two minutes before trying
again. After the third 15 second crank
attempt, allow solenoid to cool for
10
minutes before further cranking
attempts. If engine still does not start, refer
to Section 9. Troubleshooting.
WARNING
If starter engages with steering wheel
unlocked, ground speed lever out of Neutral,
or header clutch engaged, DO NOT START
ENGINE. See your Dealer.
h. Cold Start – engine temperature below 40 °F
(5 °C)
1. Follow procedure for Normal Start.
2. Engine will cycle through a period where it
appears to labour until engine warms up.
NOTE
Throttle is non-responsive during this time
as engine is in WARM UP mode. This mode
will last from 30 seconds to 3 minutes
depending on temperature. After engine has
stabilized and is idling normally, throttle
becomes active.
IMPORTANT
Do not operate engine above 1,500 rpm
until engine temperature gauge is above
100 °F (40 °C).
WARNING
If starter engages with steering wheel
unlocked, ground speed lever out of Neutral,
or header clutch engaged, DO NOT START
ENGINE. See your windrower Dealer.
6.3.5.2 Engine
Warm-Up
Allow engine to run with
throttle lever (D) at or
near low idle position
until temperature gauge
reaches approximately
100
F (40
C).
D
B
E
Содержание M205 2012
