MAINTENANCE AND SERVICING
169469/169470/169471
169
Revision E
7.10 ELECTRICAL SYSTEM
Electrical schematics are included in this section.
7.10.1 BATTERY
WARNING
Gas given off by
battery electrolyte
is explosive. Keep
all smoking
materials, sparks
and flames away
from batteries.
Follow proper charging and boosting
procedures given in this section.
Ventilate when charging in enclosed
space.
Always wear protective eye-wear when
working near batteries.
Do not tip batteries more than 45
to avoid
electrolyte loss.
Battery electrolyte causes severe burns.
Avoid contact with skin, eyes, or clothing.
Keep batteries out of reach of children.
If electrolyte is spilled or splashed on
clothing or the body, neutralize it
immediately with a solution of baking soda
and water, then rinse with clean water.
Electrolyte splashed into the eyes is
extremely dangerous. Should this occur,
force the eye open, and flood with cool,
clean water for five minutes. Call a doctor
immediately.
To avoid shocks, burns or damage to
electrical system, disconnect battery
ground cable before working in an area
where you might accidentally contact
electrical components.
Do not operate the engine with alternator
or battery disconnected. With battery
cables disconnected and engine running, a
high voltage can be built up if terminals
touch the frame. Anyone touching the
frame under these conditions would be
severely shocked.
When working around storage batteries,
remember that all of the exposed metal
parts are “live”. Never lay a metal object
across the terminals because a spark or
short circuit will result.
7.10.1.1 Maintenance
CAUTION
Do not attempt to service battery unless you
have the proper equipment and experience to
perform the job. Have it done by a qualified
Dealer
a. Check battery charge
once a year
, more often if
operating in cold weather. Hydrometer readings
should be 1.260 to 1.300. Readings below 1.250
indicate charging is required. See Section 7.10.1.3
Charging. Add electrolyte if necessary. See
Section 7.10.1.5 Adding Electrolyte.
b. Keep battery clean by wiping it with a damp cloth.
c. Keep all connections clean and tight. Remove any
corrosion, and wash terminals with a solution of
baking soda and water. A light coating of grease
on terminals (after cables are attached) will reduce
corrosion.
d. To prolong battery life, store batteries fully
charged and at +20
F to +80
F (-7
C to +26
C).
Check voltage after storage, and recharge as
needed, according to battery and charger
manufacturer recommendations.
e. Do not stack storage batteries on top of each
other.
7.10.1.2 Battery Main Disconnect Switch
A battery main disconnect switch is located on the
RH frame rail, just behind the batteries, and can
be easily accessed by moving the maintenance
platform. Ensure switch is switched to POWER
OFF position when performing major servicing to
electrical components, or for periods of non-use to
prevent inadvertent loss of battery charge.
Содержание M205 2012
