MacDon M205 2012, Руководство оператора

Страница: 119 / 230

HEADER OPERATION – A SERIES
169469/169470/169471
117
Revision E
6.6.5 KNIFE SPEED
The ideal cutting speed of the knife should be
such that a clean cut is achieved. Crop types and
conditions usually influence the knife and forward
speeds.
The Windrower Control Module (WCM) reads a
code from the header that determines the knife
speed range and the minimum speed when the
header is first attached to the windrower. The
desired speed can be programmed on the Cab
Display Module (CDM), and is stored in the WCM
memory so that if the header is detached and then
re-attached to the windrower, the knife will operate
at the original set-point.
If no header code is detected, the CDM displays
NO HEADER, and the knife speed reverts to a
range from 800–1,000 strokes per minute, and the
Operator can then pre-set the speed.
Header Description
Knife Speed *
(Strokes Per Minute [SPM])
Type Size Minimum Maximum
Auger A40-D All 1,400 1,950
Auger A30-D All 1,550 1,950
* Suggested Overload Setting – 75% of Knife Speed.
NOTE
The knife speed cannot be programmed
outside the range specified for each header.
NOTE
The speed can be adjusted without shutting
down the machine, although it is
recommended that the windrower be
stopped to enable the Operator to
reprogram the WCM.
Display and set knife speed on-the go as follows:
CAUTION
Check to be sure all bystanders have cleared
the area.
PRESS
PROGRAM/SELECT
DISPLAY SHOWS
#### KNIFE SPM
DONE
SPEED
O.K.?
NO
YES
ON CDM PRESS
LEFT ARROW or RIGHT ARROW
DISPLAY
SLOWER
FASTER
PROGRAM/SELECT