MAINTENANCE AND SERVICING
169469/169470/169471
186
Revision E
7.11 HYDRAULIC SYSTEM
The M205 Windrower hydraulic system provides
oil for the windrower drive system, and the header
lift and drive systems.
WARNING
Avoid high pressure fluids. Escaping fluid can
penetrate the skin causing serious injury.
Relieve pressure before disconnecting
hydraulic lines. Tighten all connections before
applying pressure. Keep hands and body away
from pin-holes and nozzles which eject fluids
under high pressure. Use a piece of cardboard
or paper to search for leaks. If ANY fluid is
injected into the skin, it must be surgically
removed within a few hours by a doctor
familiar with this type of injury or gangrene
may result.
IMPORTANT
Dirt, dust, water and foreign material are the
major causes of trouble developing in the
hydraulic system. If the hydraulic system
should be disconnected for service, protect
the ends of hoses, tubing and ports of
components from contamination with clean,
lint-free towels or clean plastic bags.
Before installing any replacement hose,
flush the inside of it with unused diesel fuel
or unused commercial petroleum cleaning
solvent for ten seconds minimum. Do not
use water, water soluble cleaners or
compressed air.
IMPORTANT
The components in this system are built to
very close tolerances and have been
adjusted at the factory. Do not attempt to
service these components except to
maintain proper oil level, change oil and
filters and to adjust relief pressures as
described in this manual. See your
windrower Dealer for all other service.
7.11.1 OIL LEVEL
Check hydraulic oil level daily as follows:
DANGER
Stop engine, and remove key from ignition
before leaving Operator’s seat for any reason.
A child or even a pet could engage an idling
machine.
IMPORTANT
To prevent damage to the lift system when
lowering header lift linkages without a
header or weight box attached to
windrower, ensure that float engagement
pin is installed in storage location (A), and
not
installed at hole location (B).
a. Park windrower on level ground, and lower header
and reel so that lift cylinders are fully retracted.
b. Stop engine, and remove key.
c. Stand on left cab-forward side platform to access
the filler pipe.
d. Turn filler cap counterclockwise approximately
one-quarter turn to unlock, and remove cap and
dipstick.
B
A
Содержание M205 2012
