Lotus Esprit Series, Руководство по ремонту

Страница: 89 / 362

Page
If a new i s to be fitted for reason complete kit, Part N o . w i l l
be required for each screen.
TO
REMOVE
For windscreen remove the wiper sun visors, upper
front heodlining trim finisher and pull off trim. For the
glass
remove the electrical connections to the glass heater.
Remove the finishers from around the glass. These can be removed
b y prising off, which w i l l damage the finishers, therefore, new
w i l l be required when refitting.
3.
D r i l l small diameter hole through the material, near the
'A'
post joint to the body. Insert a length of piano wire (or similar)
1
yard
( 1
metre) long through the hole. W i t h the aid of a
second operator inside the car, use a sawing action with the wire cut
through the to free the screen. Take care not to
damage the interior trim during the cutting operation.
4. Remove remaining material and the trim clips. Wipe
the body with spirit or similar until the surface i s perfectly
clean.
I f
traces of material (such are still
visible use Cleaner N o .
4
t o remove and wipe dry.
TO
REPLACE
glass primer over the cleaned flange area, f i t new trim clips
and where a
pp
licable seal the pop rivet heads. Wipe over pap rivets and
clips with Wipe Cleaner N o .
4
wipe dry. Apply glass primer over the
cleaned and after primer has dried seal over rivets with 71904.
2.
Place glass an body flonge and position correctly on the vehicle centre line
Mark position with tape from glass to body, cut tape so that relocation
of
correct position can be achieved b y lining up on tape:
NOTE:
O n windscreens tape i n line with the lower edge of the
to give neot edge to the bonding material when tape i s removed.