Lotus Esprit Series, Руководство по ремонту

Страница: 68 / 362

Page
B40
ends of the trim clips, crossed the end. Press into the surface
of the at re
g
ular intervals the small spacers on which the
w i l l rest.
6. With the aid of a second operator, l i f t screen position on the
body, ensuring that the screen i s fitted so i t i s resting on the
spacers.
7.
Connect the wire ends of the to the transformer, switch on the
current and apply hand pressure to the exterior of the screen,
positioning the hands approximately
50
cm (or 18 in) each edge
on the line.
As
warms and starts to
flow, continue to apply hand pressure (2-3 minutes), the screen w i l l
then be felt to move slowly inwards, stopping when i t reaches the
spacers. Do not pressure once the screen is against the
spacers, as excessive pressure w i l l cause the screen to crack. Con-
?
.:
. . .
.
. ..
transformer and using side cutters trim flush with the screen.
8.
The mitres on the windscreen should be checked
before fitting ensure a snug f i t when i n place.
9.
Fit the corner inserts (Part N o . i n the top left and right
hand mitres and position the assembly on the retaining clips.
10.
When satisfied the finishers are located correctl
y
, press finishers dawn
to the retaining clips, starting the corners first.
11.
Water test the screen replacement, but when the
i s
completely 2 hours after fitting), i f satisfactory,
continue the replacement process. I f unsatisfactory, remove the
screen and repeat
1
to
10
inclusive.
12.
Dry off water and replace wiper assembly. Check
operation of mechanism. screen and its
surrounding area. Re-paint lower edge screen with black paint.
13.
Replace upper front headlining finisher and both the sun visors.
HEADLAMPS
The headlamps are raised and lowered by an electric motor, which i s located i n the
front compartment, next to the left hand pod.
A
knurled protruding from
ESPRIT