Lighthouse SOLAIR 1100LD, Руководство по эксплуатации

Страница: 17 / 188

00
248083395-1 Rev 9 2-1
2
Introduction
Overview
This operating manual describes how to use the Lighthouse SOLAIR
1100LD.
The model number signifies the minimum particle size measured by the
instrument. The number “1100” indicates a 0.1
P
m minimum channel
size at 1.0 CFM (28.3 LPM).
The SOLAIR 1100LD design incorporates a stainless steel enclosure
that is easier to wipe down; RS485, Ethernet and USB interfaces; six or
eight particle-size channels; color touch screen interface; an optional
built-in thermal printer and optional internal rechargeable batteries in a
smaller, lighter package than other 0.1
—
m counters.
Note:
For lists of the
standard channel sizes
available for each SOLAIR
model, see the SOLAIR
Specifications section in
this chapter.
All SOLAIR instruments contain a microprocessor that controls all of
the instrument functions. Count data is displayed in cumulative or
differential mode as raw data or normalized in particles per cubic foot
or cubic meter.
The 1100LD uses an Extended Life laser-diode light source and
collection optics for particle detection. Particles scatter light from the
laser diode and the collection optics collect and focus the light onto a
photo diode that converts the bursts of light into electrical pulses. The
pulse height is a measure of particle size. Pulses are counted and their
amplitude is measured for particle sizing. Results are displayed as
particle counts in the specified size channel.
Description
The large color touch screen makes the 1100LD easy to configure and
operate. The 1100LD stores up to 3000 data records from up to 8
particle count channels. All data can be quickly and reliably
downloaded to a computer, flash drive or printed to the optional printer.
Note:
Hard copy reports
are available only if the
optional thermal printer is
installed. Data can be
viewed on the SOLAIR
without the printer.
SOLAIR family instruments allow a user to:
• Set sample and hold times.
• Configure the number of samples taken in a single location.
• Print reports based on Federal Standard 209E (ft
3
), EU GMP (if
unit has active 0.5 and 5.0
—
m. channels) and ISO 146441-1.