Lighthouse SOLAIR 1100LD, Руководство по эксплуатации

Страница: 67 / 188

Operate SOLAIR
248083395-1 Rev 9 6-3
9. If analog sensors were ordered, plug them into the connectors
labeled 1 or 2 on rear of the instrument (see Figure 6-5).
Figure 6-5 Analog Channel Connectors
10. Make sure the Inlet port is not capped or plugged and is properly
connected to sample tube then press the “START” button on the
touch screen to start the instrument.
Figure 6-6 Instrument Start Button Example
WARNING:
Never operate the instrument with the inlet tube capped or
plugged. Failure to heed this warning may damage the internal pump
and void the warranty.
• If the 5-Sec Startup is set (default), “STARTING” will display for
five seconds when the pump turns on.
• When the SOLAIR starts counting, "COUNTING" appears on the
display. Particle counts are displayed according to the size of each
particle.
• If the instrument has been programmed with a delay before starting
the pump, it displays, “DELAY”.
• If the instrument is in AUTO mode with cycles and a hold time,
“HOLDING” will display after each cycle and “FINISHED” will
display when all the cycles are complete.
• Press the "STOP" button to stop the instrument, if required, before
the cycles are complete.
Analog 1 Input
Analog 2 Input
Start Button - will
become the Stop
Button when running