Lighthouse SOLAIR 1100LD, Руководство по эксплуатации

Страница: 129 / 188

Operate SOLAIR
248083395-1 Rev 9 6-65
REPORTS
The SOLAIR can print the following Cleanroom Classification to
Standards reports:
Note:
The EU GMP 2009
report is only valid if the
instrument is configured with
the 0.5 and 5.0 micron
channel sizes.
Federal Standard ft
3
ISO 14644-1
EU GMP 2009
Reports General Settings
Note:
If the user sets the
counter for a minimum
volume, and takes the exact
number of minimum locations
and samples, the user could
get a “Cannot Classify: too
few locations” error if the
minimum volume rounds the
sample time down so that not
enough samples at the
minimum volume are taken.
In this case, add one or two
seconds to the sample time
so that the user is not at the
exact minimum volume.
Enable the Reports feature by pressing the red “ X ” (Default position)
located at the top left of the screen. The button will display a check
mark indicating the feature is enabled. See Figure 6-86.
Figure 6-86 Typical Reports Screen
• Depending on the reports requirements, the number of cycles and
minimum sample time will be calculated when the reports mode is
enabled.
• The number of required locations will be automatically assigned to
the report. The user may change locations via the reports SETUP
screen.
• The display format will be changed to Normalized (normalized to
ft3 for FED-209 and m3 for ISO and EU GMP). The user may
change the display mode from the reports SETTINGS screen.