Lighthouse SOLAIR 1100LD, Руководство по эксплуатации

Страница: 16 / 188

Lighthouse SOLAIR 1100LD Operating Manual
1-2 248083395-1 Rev 9
If replacement of a battery or AC power cord is required,
replace them only with a battery or power cord having as
good as or better rating than those provided by Lighthouse
Worldwide Solutions. Attempting to use an under-rated
cord or battery can expose the instrument power supply,
adjacent equipment or the user to dangerous shock, fire or
explosion hazards. Failure to heed this warning can result
in personal injury or death.
For further technical assistance, contact Lighthouse at 1-800-945-5905
(Toll Free USA) or 1-541-770-5905 (Outside of USA).
WARNING:
+24VDC is
present on RS-485 port
pin 7 when instrument
power is applied.
The international Caution symbol is located on the rear of the
instrument next to the RS-485 port. The symbol will be accompanied
in this manual with a warning that +24VDC is present on connector
pin-7 when instrument power is applied.
Port-Connect
Warning
WARNING: Connect to the SOLAIR 1 CFM instrument using
the Ethernet port (upper RJ45), RS485 port (lower RJ45) or
USB port. The instrument will determine which port should
be active and configure it accordingly. Only one interface
can be active at a time. Do NOT attempt to use two or more
of these connectors at one time.
It is suggested that power to the instrument be removed
before changing from one port to another then power the
instrument ON. This warning does NOT apply to the USB
Flash Drive.
Electrostatic
Safety
Information
Electrostatic discharge (ESD) can damage or destroy electronic
components. Therefore, any service or maintenance work should be
done at a static-safe work station. A static-safe work station requires an
ESD consultant to evaluate the work environment and propose the
equipment and apparel needed for just such a work station to be
successful.