Lighthouse SOLAIR 1100LD, Руководство по эксплуатации

Страница: 53 / 188

Set up the Counter
248083395-1 Rev 9 4-19
5. A command prompt window will open. Clear the ARP Cache by
typing
arp -d * at the command line and press Enter . Ignore any
error messages that indicate the address table doesn’t exist or has
no entries. See Figure 4-15.
Figure 4-15 Clear Address Table Command
6. The next step requires the unit’s assigned IP and its MAC
address. The MAC address is a group of six two-digit characters
(0-9 and A-F) found on the back of the 1100LD that may be
referred to as the HW address.
7. The next step adds the IP and MAC addresses to the ARP Cache
which allows direct communications with the instrument before
an IP is programmed into its Ethernet interface.
8. Type arp –s xxx.xxx.xxx.xxx nn-nn-nn-nn-nn-nn and press Enter .
Replace the x’s with the desired IP address, such as 192.168.0.10
or 10.10.0.15, and the n’s with the desired MAC address, such as
00-20-4a-8a-26-31. The IP address will be four segments total
with up to 3 digits per segment, each segment separated by a
period. Note that the MAC address segments are separated by
dashes (-), not periods. See Figure 4-16. This command tells the
Operating System (OS) that it must assign the IP address to the
MAC address to make the following commands work.
Figure 4-16 ARP Command to Add New IP
9. Activate the SOLAIR’s Ethernet interface by typing, telnet
xx.xx.xx.xx 1 (replace x’s with the IP address to be used for the
instrument) and press Enter . This command will cause a connect
error but is required to establish communications. See Figure 4-
17.
Figure 4-17 Command - Send “Telnet 1"