Lighthouse SOLAIR 1100LD, Руководство по эксплуатации

Страница: 65 / 188

00
248083395-1 Rev 9 6-1
6
Operate SOLAIR
Instrument
First Time
Use
This chapter describes how to use the SOLAIR 1100LD Airborne
Particle Counter. The SOLAIR is ready to use, aside from site
requirements, right out of the box. Refer to “Installation” on page 3-5
and “Set up the Counter” on page 4-1 for specifics to prepare the
instrument for operation.
WARNING:
Do not
attempt to sample
reactive gases (such as
hydrogen or oxygen)
with this instrument.
Reactive gases create an
explosion hazard in the
instrument.
Sampling any gas under
pressure can damage the
instrument and void its
warranty.
Sampling any gas that is
not the same density as
ambient air can result in
inaccurate data.
Please contact
Lighthouse at 800-945-
5905 (Toll Free USA) or
541-770-5905 (Outside of
USA) for more
information.
1. Install the instrument’s battery according to instructions in
Chapter 3.
2. Position the instrument in the environment to be measured (per
Chapter 3).
3. Make sure the front power switch is OFF (not illuminated).
Figure 6-1 SOLAIR 1100LD Power Button
4. Plug AC power cord into SOLAIR and AC outlet. Make sure
enough space exists to allow quick and safe removal of the AC
cord if needed. See Figure 6-2.
Figure 6-2 AC Power Input Connection
Power
Button
AC Power Input