Lighthouse SOLAIR 1100LD, Руководство по эксплуатации

Страница: 50 / 188

Lighthouse SOLAIR 1100LD Operating Manual
4-16 248083395-1 Rev 9
• TCP/IP - a communication protocol suite that is used for the
Internet and a large number of LANs that allows hosts to share
data.
• Telnet - a communication program used primarily to issue
commands directly to a TCP/IP-based host.
Prepare for
Network
Installation
Equipment Required:
• Network enabled Personal Computer (IBM-compatible);
• SOLAIR 1100LD
Note:
The network
where the instruments will
operate must have an
available IP address for
each instrument. The IP
scheme (subnet) must
match that of the PC that
will be used to retrieve the
data from the instruments.
Contact Lighthouse
Technical Support at 800-
945-5905 (Toll Free USA)
or 541-770-5905 (Outside
of USA) for additional
information.
• Small 5-port hub or switch and two 3-foot long straight-through
Cat5 Ethernet cables (for connection to a Network)
• Or one 3-foot cross-over Cat5 Ethernet cable (for connection to a
PC)
Software Required:
Contact the network administrator if any of the following are not
installed or not functional:
• Windows 2000, XP Professional or Windows 7 OS
• Telnet
Note:
All values in
screen shots are examples
only. Use only the values
provided by the Network
Administrator.
Additional Requirements:
1. Contact the network administrator and obtain administrator rights
on the PC to be used for this procedure.
2. For each counter to be attached to the LAN, obtain an unused
static IP address, a Gateway IP address and appropriate Netmask
for the LAN in which they will be installed.
3. Create a list and record the MAC address(es) for all SOLAIRs to
be configured. It is suggested that the IP address that will be used
for each SOLAIR be written next to the MAC address. This list
can be provided to the network administrator for future reference.
4. The PC being used to program the SOLAIR must be using the
same subnet that the adapter will use. See the network
administrator for assistance with this.
5. The PC that will monitor or retrieve data from the instrument(s)
must be using the same subnet and gateway programmed on the
SOLAIRs) network interface.