Lighthouse SOLAIR 1100LD, Руководство по эксплуатации

Страница: 52 / 188

Lighthouse SOLAIR 1100LD Operating Manual
4-18 248083395-1 Rev 9
Cross-over Cat5 Setup:
1. Attach one end of the cross-over cable to the Ethernet RJ45
receptacle on the PC.
2. Attach the other end of the cable to the SOLAIR Ethernet Port.
3. Apply power to the SOLAIR then to the PC if it is not already
running. Observe the LEDs on the PC’s RJ45 connector -
blinking indicates network activity. Observe the network LEDs
on the instrument’s RJ45 receptacle - they should blink indicating
activity. Proceed to next section.
Program the
Interface
Windows Telnet Programming:
1. Start Windows.
2. On the Taskbar, click on Start .
WARNING:
Perform
only the steps or
commands as provided
in this guide. Failure to
heed this warning can
result in damage to
equipment, personal
injury or data loss and
may void the equipment
warranties.
3. Select Run as shown in Figure 4-13.
Figure 4-13 RUN Screen
4. In the Run window, type CMD and click OK. See Figure 4-14.
Note:
Typing commands
in the command console
requires a space between
the instruction and the
command variables. For
example,’arp’ is followed
by a space, then’-d’ and
another space, then the *.
Figure 4-14 Starting the Command Console