Lighthouse SOLAIR 1100LD, Руководство по эксплуатации

Страница: 34 / 188

Unpack, Inspect and Install
248083395-1 Rev 9 3-14
How to Replace Fuses
To replace fuses, disconnect AC supply cord from instrument. The fuse
tray is located on the bottom of the power inlet (Figure 3-17).
Figure 3-17 Replacing Fuses
1. Remove power cord and note fuse tray location (Figure 3-17, #1).
2. Using a small flat blade screwdriver, insert tip under lip of fuse tray
and pry gently outward. See Figure 3-17, #2.
3. Remove tray then remove and discard fuses from tray.
4. Lay new fuses (SloBlo, 2A, 250V, 5x20mm) into the side slots of
the tray. Contact Lighthouse for LWS P/N 017-808915.
5. Grasp the tray in a manner that holds the fuses in the tray, as shown
in Figure 3-17, #5. Place tray into opening, release hold on fuses
and slide tray in slowly until fuses engage fuse sockets inside AC
Power Inlet box. Push in firmly until tray is flush with Inlet body.
6. Reinstall power cord and test unit to verify fuse replacement
worked. For additional assistance, contact Lighthouse Support at
1-800-945-5905 (toll-free USA) or 1-541-770-5905 (outside USA).
Small flat screwdriver to pry
Fuses loose in tray
Ready to
Fuse tray
insert fuse tray
#1
#2
#4
#5