7.
Verify that the appropriate bandwidths are shown on line 1 when
all 24 DS0s are bundled as desired. (Besides misassignment of
DS0s, a possible cause of incorrect bandwidth numbers is improper
selection of DTE rates, which may be Nx56 or Nx64 kbps.)
8.
Press the
Enter
key if the DS0 assignments and bandwidth numbers
are correct.
9.
Verify that
ENTERED
appears at the left end of line 2.
10. Press the
Esc
key.
Time-of-Day Switching of DS0 Maps
Access-T can switch automatically between the two DS0 maps at user-specified
times each day. Setting Access-T for automatic switching is a two-stage process.
First, the switching times must be defined, and second,
TIME
must be enabled as
the current mapping option.
Note:
Access-T must be in an ESF point-to-point application,
and only one Access-T can be configured for
TIME
mode at a
time.
To define the map-switching time, follow these steps:
1.
Select
SYSTEM
from the Main Menu.
2.
Select
DS0 CONFIGURATION
.
3.
Select
TIME
.
4.
Select
START TIME
. This value will determine the time that Map 1
becomes the active map, and Map 2 becomes inactive.
5.
Key-in the desired start time.
6.
Select
STOP TIME
. This value will determine the time that Map 1
becomes inactive, and Map 2 becomes the active map.
7.
Key-in the desired stop time.
8.
Verify that the start and stop times are as desired.
9.
Press the
Esc
key to return to the Main Menu.
10.
Enable timed switching of DS0 maps as described in the next
procedure.
ACST-0351-005
Chapter 6
June 1996
Configuration Procedures
6-19
