Isel ICP 4030 iMC-P, Инструкция по сборке/Руководство по эксплуатации

Страница: 46 / 71

ICP 4030 iMC-P
45
/71
January
2018
7 Cleaning, lubrication and maintenance
Turn off the main power switch before cleaning and maintenance
and unplug the power plug (s) to prevent any accidental start-up.
7.1 Cleaning
•
Clean the machine regularly with a broom or vacuum cleaner (no compressed air)
to remove any chips. This protects the mechanics from premature wear.
•
The sealing lips include a Teflon component and require no special maintenance.
•
The plastic discs can be cleaned with a non-abrasive plastic cleaner.
7.2 Lubrication
•
The guide rails and drive shafts are given a long-term central lubrication in the
factory. Depending on the load, you should re-lubricate the guides and drive shafts
at intervals of about 500-1000 hours of operation. For this, use the grease gun
available as an accessory for central lubrication and the associated special grease.
•
Do not lubricate too much at once, the shafts and steel rails should not be
swimming in grease.
•
If you want to lubricate, first do a reference run, then open the door and only now
switch off the machine.
7.2.1 Basic lubrication
The drive components are lubricated at the factory with isel special grease.
They can be started right away.
The EC safety data sheet as per Directive 93/112/EEC and ISO 11014-1 can be
requested from the factory.
7.2.2 Re-lubrication
To re-lubricate the linear bearings with shafts, only the isel special grease should
be used.
The grease required can be ordered using the following article numbers:
•
299032 0002 grease cartridge
•
299032 0003 grease gun
Depending on the application, we recommend re-lubrication every 500 to 1000
operating hours.
To lubricate the X axis
, slide the carriage to the left*, remove the plastic plug on the
left side of the machine and lubricate through the greasing nipple, which is now
visible. The guide rails can be accessed through the sealing lips.