Isel ICP 4030 iMC-P, Инструкция по сборке/Руководство по эксплуатации

Страница: 15 / 71

ICP 4030 iMC-P
14
/71
January
2018
4 Setting up and connecting the CNC machine
4.1
Scope of supply
The machine is delivered fully assembled on a pallet. In the scope of delivery of
the ICP 4030, Art no.: 280270 XXX
the following are contained:
▪ Machine housing including:
o
three drive axes with ball screw spindle 16 x 10mm or 4mm, 2-phase
stepper motors and two limit switches
o
Protective cover with solenoid interlock
▪ Stepper motor control behind the machine rear wall included:
o
Mains input filter with main switch and fuses
o
2-phase stepper motor output stages for 4 axes with max. 4
A rated current
o
Connection board with processor (core module)
o
Safety circuit module (SK module)
o
48V power supply unit and 24V power supply unit
o
Function keys and emergency stop on the front of the machine
▪ Triangular key for unlocking the cover switch
▪ Mains supply line, communication line
▪
Remote as software (optional: ProNC:
▪ Operating instructions
4.2
Delivery status ex works (quality assurance)
The ball-bar measuring system QC10 Renishaw is used to demonstrate / check the
machine accuracy of the CNC machines.
This system determines the precision of the axes of all CNC machines / CNC basic
machines produced before the delivery.
Ball-bar measuring system QC10
The assembly of the QC10 is possible on each tool machine and only takes a few
minutes. The ball-bar measurement is controlled via a simple, standardised CNC
programme. The data is identified in the diagnostic software, evaluated and the faults
displayed graphically/in a table with their size and the corresponding impact on the
overall accuracy.
The form of the circuits detected (in all three interpolation levels XY/XZ/YZ)
gives indications of possible machine faults:
•
Tracking errors / position tolerance
•
Straightness error / square
•
Dimensional error / backlash
•
Quadrant transition / circular deviation