PAGE 1 OF 6
0521 IH-1381
π
H-1381
DRUM OPENER
1-800-295-5510
uline.com
OPERATION
WARNING! H-1381 Drum Opener is NOT a
non-sparking device. Never use where there is
any possibility of ignition from sparks.
WARNING! The Drum Opener is designed for
use only with steel drums. Do not use to open
any type of fiber or plastic drums.
WARNING! All threaded parts must be tight
except for the adjustment knobs.
1. Turn back the adjustment knob to extend the drum
opener to the fully open position for maximum
blade clearance over drum chime. (See Figure 1)
2. Tilt the handle over the drum and place the groove
in the cutter base on top of the drum chime.
(See Figure 2)
3. With blade over the chime, tighten the knob to
slowly bring the cutter base firmly in contact with
the side of the drum. The blade should contact the
inside edge of the chime. (See Figure 3)
4. Turn back the adjustment knob slightly so that the
blade does not bind and wedge drum chime
between blade and cutter base. (See Figures 4-5)
Cutter Base
Drum Chime
Blade
Adjustment
Knob
Figure 1
Cutter Base
Figure 2
Blade
Drum
Chime
Figure 3
Blade
Drum
Chime
Cutter
Base
Figure 4
Rear
View
Drum
Chime
Figure 5
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
