Isel ICP 4030 iMC-P, Инструкция по сборке/Руководство по эксплуатации

Страница: 25 / 71

ICP 4030 iMC-P
24
/71
January
2018
5.4
Connections on the stepper motor controller
5.4.1 Safety notices
All work on the electrical installation must only be carried out by
authorised and trained personnel. Any changes to the electrical
installation will void the warranty and CE conformity. When
adding to the machine (e. g. working spindle, inverters, actuators,
sensors, etc.), the operator is responsible for ensuring that all
safety regulations in accordance with EN 60204-1 are complied
with.
5.4.2 Access to the stepper motor controller and its components
To access the connections of the stepper motor controller, please proceed as
follows:
Disconnect the mains plug of the machine!
Remove the machine's cover plate by loosening the
hexagonal screws and pulling the earth cable from
the cover plate.
Now you can connect additional components (e. g.
frequency inverters, solenoid valves, sensors, actuators,
etc.) to the connections of the stepper motor controller.
Opening the housing of the stepper motor controller
As a rule, it is not necessary to access the built-in components inside the stepper motor
controller. The opening of the housing cover may only be carried out by authorised and
trained personnel.
After removing the rear panel of the machine, remove the housing of the stepper motor
controller. Loosen the Phillips-head screws on the top of the housing cover and remove
it. Components such as stepper motor power amplifiers, SK modules, switching power
supplies, etc. can now be reached.