Isel ICP 4030 iMC-P, Инструкция по сборке/Руководство по эксплуатации

Страница: 18 / 71

ICP 4030 iMC-P
17
/71
January
2018
4.6 Coordinate system and reference point
The coordinate system of the machine is defined as shown in the illustration,
whereby you can freely select (move) the component zero point P0 via the software.
The reference point of the machine (machine zero point) is set in front (Y) at the factory on the
left (X) above (Z).
Stickers on the machine indicate the axes.
4.7 Processing machine
The standard machine tool (accessory, not included in
the scope of delivery) can accept different tools with a
maximum shaft diameter of 6.35 mm in the collet (4)
(standard 3 mm, other Ø see accessories).
Use two open-end wrenches SW 22 to change the collet
chuck. The power for the processing machine is
released via the software.
The speed of the machine can be set manually with the
wheel (1).
To disassemble the machine tool, turn off the main switch of the
ICP, remove the power cable from the distributor box, loosen the
clamping screw (2) and remove the machine tool from its bracket.
To disassemble the machine with the bracket, remove the power
cable, loosen the two outer screws (3) (only loosen, do not
unscrew completely) and remove the machine with the holder
and T-slot nuts out downwards.