ICU Medical LifeCare PCA, Техническое и сервисное руководство, Страница: 101 / 148

7.3 REPLACEMENT PROCEDURES
Technical Service Manual 7 - 9 LifeCare PCA
7.3.5
AC POWER CORD REPLACEMENT
The recommended tool for this procedure is a No. 2 Phillips screwdriver.
The replacement part for this procedure is:
Cordset, AC Power, Hospital Grade
To replace the AC power cord, see
Figure 7-4
, and proceed as follows:
1. Disconnect the infuser from AC power.
2. Using the Phillips screwdriver, remove the 6-32 screw that attaches the battery door
to the rear of the infuser.
3. Disconnect the defective AC power cord by grasping the plug. Do not pull
on the cord.
4. Replace the AC power cord by plugging it into the infuser’s AC power receptacle.
5. Reinstall the battery door with the screw that was removed in Step 2.
6. Connect the infuser to AC power and confirm the AC indicator is lit.
To verify successful AC power cord replacement, perform the Electrical Safety Test
in
Section 5.6.8
.
If the infuser may have been damaged during this procedure, perform the PVT
in
Section 5.6
.
7.3.6
BATTERY, BATTERY DOOR, DOOR PAD,
AND BATTERY STRAP REPLACEMENT
Recommended tools and materials for this procedure are:
Replacement parts for this procedure are:
Assembly, Battery, with Wire Harness
Door, Battery
Pad, Battery Door
Strap, Battery
Screw, 6-32 x 1/4, Pan Head, Phillips
Screw, 4-24 x 3/8, Thread Cutting, Phillips
Washer, Flat, #6
- No.1 Phillips screwdriver
- No. 2 Phillips screwdriver
- Long needle nose pliers
- Battery cable connector tool (P/N 519-89318-001), or equivalent
- Isopropyl alcohol
- Lint-free cloth