IBM SAN32M-2, Инструкция по установке и обслуживанию

Страница: 79 / 312

53 Chapter 2: Installation tasks
4. At the Computer Name field, change the name to MGMTSERVER .
Click (select) the Workgroup radio button, change the name to
WORKGROUP , and click OK . The dialog box closes.
5. Record the computer and workgroup names for reference if the
server hard drive fails and must be restored.
6. Close all dialog boxes and return to the Windows desktop.
Configure gateway and DNS server addresses
To configure gateway and DNS server IP addresses for the private
LAN connection (
LAN 2 ) and public LAN connection ( LAN 1 ):
1. At the Windows desktop, click Start at the left side of the task bar
(bottom of the desktop), then sequentially select Settings , Control
Panel , and Network and Dial-up Connections . The Network and
Dial-up Connections window displays.
2. To configure addresses for the private LAN connection (
LAN 2
),
double-click the Local Area Connection 2 icon. The Local Area
Connection 2 Status dialog box displays.
3. Click Properties . The Local Area Connection 2 Properties dialog box
displays.
4. In the Components checked are used by this connection field,
double-click the Internet Protocol (TCP/IP) entry. The Internet
Protocol (TCP/IP) Properties dialog box displays ( Figure 24 ).
5. The Use the following IP address radio button is enabled and the IP
address and Subnet mask fields display network information
configured while performing Task 6: Configure server password and
network addresses .
6. At the Default gateway field, enter the gateway address obtained
from the customer.
7. Select (enable) the Use the following DNS server addresses radio
button. At the Preferred DNS server field, enter the DNS server IP
address obtained from the customer, then click OK to apply the
changes and close the dialog box.