IBM SAN32M-2, Инструкция по установке и обслуживанию

Страница: 144 / 312

SAN32M-2 Installation and Service Manual 118
i. At the C > prompt, type the ipconfig command and press Enter .
The New Connection - HyperTerminal window displays with
configuration information listed.
j. Record the product IP address.
k. Select Exit from the File pull-down menu. A HyperTerminal
message box appears.
l. Click Yes . A second message box appears. Click No to exit and
close the application.
m. Power off the maintenance terminal and disconnect the modem
cable. Replace the protective cap over the maintenance port.
Continue to the next step.
22
Define the product IP address (determined in step 21 ) to the
management server.
a. At the SAN management application, select Setup from the
Discover menu. The Discover Setup dialog box displays.
b. Ensure the product to be reconfigured is moved from the
Selected Individual Addresses list to the Available Addresses
list. Select (highlight) the product and click Edit . The Address
Properties dialog box displays with the IP Address page open.
c. Type the correct product IP address in the IP Address field.
d. Move the reconfigured product from the Available Addresses list
to the Selected Individual Addresses list.
e. Click OK to save the address, close the dialog box, and redefine
the product to the SAN management application.
f. Click OK to close the Discover Setup dialog box.
Was the maintenance action successful?
NO YES
↓
The management server connection is restored. Exit MAP.
Contact the next level of support. Exit MAP.
23
An incorrect product type is defined to the management server.
a. At the SAN management application, select Setup from the
Discover menu. The Discover Setup dialog box displays.