IBM SAN32M-2, Инструкция по установке и обслуживанию

Страница: 178 / 312

SAN32M-2 Installation and Service Manual 152
• Ethernet LAN interface, causing the connection to the browser PC
or management server to drop momentarily until the connection
automatically recovers.
• Ports, causing all Fibre Channel connections to drop momentarily
until the connections automatically recover. This causes attached
devices to log out and log back in, therefore data frames lost
during switch reset must be retransmitted.
IML
To IML the switch:
1. Press and hold the
RESET
button (about three seconds) until the
amber ERR LED blinks at twice the unit beaconing rate.
2. Release the button. During the IML, the switch-to-browser PC (or
management server) Ethernet link drops momentarily.
Reset
To reset the switch:
1. Press and hold the
RESET
button for ten seconds.
— After holding the button for three seconds, the amber ERR
LED blinks at twice the unit beaconing rate.
— After holding the button for ten seconds, the ERR LED stops
blinking, and all front panel LEDs illuminate.
2. Release the button to reset the switch. During the reset:
— The green PWR LED on the switch front panel illuminates.
— The amber ERR LED on the switch front panel blinks
momentarily while the switch is tested.
— The green LED associated with the Ethernet port blinks
momentarily while the port is tested.
— Green and amber LEDs associated with Fibre Channel ports
blink momentarily while the ports are tested.
— The switch-to-browser PC (or management server) Ethernet
link drops momentarily.