IBM 8248-L4T, Руководство пользователя

Страница: 87 / 214

Replacing a disk drive or solid-state drive in the 8248-L4T, 8408-E8D,
or 9109-RMD system or expansion unit
1.
If the slot you want to use contains a disk drive filler, remove the disk drive filler from the slot. For
instructions, see “Removing a disk drive filler from the 8248-L4T, 8408-E8D, or 9109-RMD” on page
75.
2. If the drive you are installing does not have a bezel preinstalled, then complete the tasks to install a
bezel on the drive, then continue with this procedure from step 4. For instructions to install a bezel,
see “Installing a disk drive bezel in a disk drive or filler” on page 80.
3. If the drive you are installing has a bezel preinstalled, then go to step 4.
4.
Unlock the drive handle by squeezing it and pulling it out toward you. If the handle is not all the
way out, the disk drive or solid-state drive does not slide into the system or an expansion unit.
5. Hold the disk drive or solid-state drive by the top and bottom edges as you position the drive, and
insert it into the system or the expansion unit. Do not hold the disk drive or solid-state drive by the
handle.
6. Slide the disk drive or solid-state drive all the way into the system or an expansion unit, and push
the drive handle
(A) in until it locks, as shown in Figure 43.
Note: It is important to ensure that when installing a drive, that the drive is fully seated and all the
way into the system.
Proceed to the procedure for completing the disk drive or solid-state drive replacement. For instructions,
see “Completing the procedure” on page 72.
Replacing a solid-state drive in the EDR1 PCIe storage enclosure
Complete the following steps to replace a solid-state drive in the EDR1 PCIe storage enclosure.
1.
With the handle in the unlocked position, align the solid-state drive with the guide rails in the
enclosure.
Figure 43. Replacing a disk drive or solid-state drive in the system
Replacing a disk drive or solid-state drive
71