IBM 8248-L4T, Руководство пользователя

Страница: 77 / 214

1. If the drive you are installing does not have a bezel preinstalled, then complete the tasks to install a
bezel on the drive, then continue with this procedure from step 3. For instructions to install a bezel,
see “Installing a disk drive bezel in a disk drive or filler” on page 80.
2.
If the drive you are installing has a bezel preinstalled, then go to step 3.
3. Unlock the drive handle by squeezing it and pulling it out toward you. If the handle is not all the
way out, the disk drive or solid-state drive does not slide into the system or an expansion unit.
4. Hold the disk drive or solid-state drive by the top and bottom edges as you position the drive, and
insert it into the system or the expansion unit. Do not hold the disk drive or solid-state drive by the
handle.
5. Slide the disk drive or solid-state drive halfway into the system or an expansion unit.
6. On the Verify Device Concurrent Add display, verify that the selected drive is the drive you want to
replace, and then press Enter.
7.
When the identify LED flashes, slide the disk drive or solid-state drive all the way into the system or
an expansion unit, and push the drive handle
(A) in until it locks, as shown in Figure 38.
Proceed to the procedure for completing the disk drive or solid-state drive replacement. For instructions,
see “Completing the disk drive or solid-state drive replacement by using the iprconfig command” on
page 62.
Replacing a solid-state drive in the EDR1 PCIe storage enclosure
Complete the following steps to replace a solid-state drive in the EDR1 PCIe storage enclosure.
1. With the handle in the unlocked position, align the solid-state drive with the guide rails in the
enclosure.
Note:
Do not hold the drive only by the handle. Support the drive by holding the drive by its sides.
2. Slide the solid-state drive halfway into the EDR1 PCIe storage enclosure.
Figure 38. Replacing a disk drive in the system
Replacing a disk drive or solid-state drive
61