IBM 8248-L4T, Руководство пользователя

Страница: 78 / 214

3. On the Verify Device Concurrent Add display, verify that the selected drive is the drive you want to
replace, and then press Enter.
4.
When the solid-state drive identify LED flashes, slide the solid-state drive all the way into the EDR1
PCIe storage enclosure until it is fully seated. Then rotate the handle
(A) to the locked position. See
Figure 39.
5. Install the bezel (B) .
Proceed to the procedure for completing the disk drive or solid-state drive replacement. For instructions,
see “Completing the disk drive or solid-state drive replacement by using the iprconfig command.”
Completing the disk drive or solid-state drive replacement by using
the iprconfig command
Complete the following steps by using the iprconfig command:
1. Press Enter on the Complete Device Concurrent Add display to indicate that the disk drive or
solid-state drive is installed.
2.
Proceed to completing the procedure.
Completing the procedure
Complete the following steps after you install or replace the disk drive or solid-state drive in a system,
enclosure, or expansion unit:
1. Replace the front cover. For instructions, see “Installing the front cover on the 8248-L4T, 8408-E8D, or
9109-RMD” on page 147.
2. Verify the installed part:
v
If you replaced the part because of a failure, verify the installed part. For instructions, see
“Verifying a repair” on page 161.
Figure 39. Replacing a solid-state drive in the EDR1 PCIe storage enclosure.
62
Disk drives or solid-state drives