IBM 8248-L4T, Руководство пользователя, Страница: 63 / 214

12. If the physical location does not appear in the Device Concurrent Maintenance display, type the
physical location where you are replacing the disk drive as shown in the preceding example,
Figure 30.
The physical location has the following form:
U787A.001. AAAXXXX -P3-D4
where
P3-D4
is the position
of the disk drive in the system unit or expansion unit. You can get the
U787A.001. AAAXXXX
location
information from the control panel display on the system unit or expansion unit.
If you cannot get the information from the control panel, find the feature code (FC) and sequence
number (SN or SEQ) on the label that appears on the front of the system unit or expansion unit as
shown in the following figure.
In this example,
U787A.001.AAAXXXX-P3-D4
, U787A.001 comes from the feature code (FC) on the label,
AAAXXXX comes from the last seven digits of the sequence number (SN or SEQ) on the label, and
P3–D4 is the slot where you are replacing the disk drive as shown in “Disk drives or solid-state
drives locations and service indicators” on page 89.
In the example,
U5074.001. AAAXXXX -DB3-D32
, you would replace a disk drive in the expansion unit
with type 5074, model 001, sequence number AAAXXXX , and disk drive position DB3–D32.
13. Select option 1 (Remove device) for the Action to be performed .
Device Concurrent Maintenance
Type the choices, then press Enter.
Specify either physical location or resource name.
Physical location:
U787A.001.1234567-P3-D4
or
Device resource name:
Specify action as 1=Remove device 2=Install device
Action to be performed . . . . . . . .: 1
Enter a time value between 00 and 19.
Time delay needed in minutes . . . . .: 01
F3=Exit F5=Refresh F12=Cancel
Figure 30. Example Device Concurrent Maintenance display
Figure 31. Example system or expansion unit label
Removing a disk drive or solid-state
47