IBM 8248-L4T, Руководство пользователя

Страница: 79 / 214

v
If you installed the part for any other reason, verify the installed part. For instructions, see
“Verifying the installed part” on page 149.
3.
To rebuild data on the newly installed or replaced disk drive or solid-state drive, see “Rebuilding data
on a replacement disk drive or solid-state drive in a system or logical partition running Linux” on
page 100.
Replacing a disk drive or solid-state drive in the 8248-L4T, 8408-E8D,
or 9109-RMD with the IBM i system or logical partition power turned
on
Learn how to replace a Small Computer System Interface (SCSI) or serial-attached SCSI (SAS) drive in a
system or expansion unit while the power of the IBM i operating system or logical partition that controls
the drive location is turned on.
To complete this procedure you must have removed the drive. For the procedure to remove the drive, see
“Removing a disk drive or solid-state drive from the 8248-L4T, 8408-E8D, or 9109-RMD with the IBM i
system or logical partition power turned on” on page 40. If you are installing a new or upgraded drive,
see “Installing a disk drive or solid-state drive in the 8248-L4T, 8408-E8D, or 9109-RMD with the IBM i
system or logical partition power turned on” on page 17.
If you are removing a drive as part of a service procedure, continue to use the following procedure.
Note: Some of the figures in these procedures might not look exactly like the system or expansion unit
that you have. However, the steps to complete the task are the same.
Related information
:
Removing and replacing a disk drive in the 5887 disk drive enclosure unit
Preparing to replace the disk drive or solid-state drive
Complete the following steps before replacing a disk drive or solid-state drive in a system or in an
expansion unit.
1. Return to the console and wait until the Concurrent Maintenance Results display is shown.
2. Press F12.
3. The physical locations you entered while removing the disk drive or solid-state drive might still show
on the display. If not, retype the physical location where you want to install the new disk drive or
solid-state drive.
In the example,
U787A.001.1234567-P3-D4
, you would install a disk drive in the system unit with type
9406, Model 520, sequence number 1234567, and disk drive or solid-state drive position P3–D4.
In the example,
U5074.001.1234567-DB3-D32
, you would install a disk drive or solid-state drive in the
expansion unit with type 5074, model 001, sequence number 1234567, and disk drive or solid-state
drive position DB3–D32.
4. Select
2
(Install device) for the Action to be performed.
5. Set the time delay, for example, for one minute: 01 .
Note: You can set an appropriate time delay of 01 - 19 minutes to allow adequate time to access the
disk drive or solid-state drive.
Important:
Do not press Enter yet.
Choose from the following options:
v
If you are replacing a drive in a system, proceed to “Replacing a disk drive or solid-state drive in the
8248-L4T, 8408-E8D, or 9109-RMD system or expansion unit” on page 64.
Replacing a disk drive or solid-state drive
63