IBM 8248-L4T, Руководство пользователя

Страница: 38 / 214

Important: When installing a drive, ensure that the drive is fully seated and is all the way into the
EDR1 PCIe storage enclosure.
5.
Rotate the handle (A) to the locked position.
6. Install the bezel (B) .
Proceed to the procedure for completing the disk drive or solid-state drive installation. For instructions,
go to “Completing the disk drive or solid-state drive installation.”
Completing the disk drive or solid-state drive installation
1. Return to the console and wait until the Concurrent Maintenance Results display is shown, and then
press Enter.
2. When the HSM display is shown, press F12 twice and then press Enter.
Proceed to completing the procedure.
Completing the procedure
Complete the following steps after you install or replace the disk drive or solid-state drive in a system,
enclosure, or expansion unit:
1. Replace the front cover. For instructions, see “Installing the front cover on the 8248-L4T, 8408-E8D, or
9109-RMD” on page 147.
2. Verify the installed part:
v If you replaced the part because of a failure, verify the installed part. For instructions, see
“Verifying a repair” on page 161.
v
If you installed the part for any other reason, verify the installed part. For instructions, see
“Verifying the installed part” on page 149.
3.
To configure the newly installed disk drive or solid-state drive, see “Configuring a disk drive or
solid-state drive in an IBM i system or logical partition” on page 104.
Figure 13. Installing a solid-state drive in the EDR1 PCIe storage enclosure
22
Disk drives or solid-state drives