IBM 8248-L4T, Руководство пользователя, Страница: 59 / 214

8. If the physical location does not show in the Device Concurrent Maintenance display, type the
physical location where you are replacing the disk drive or solid-state drive as shown in the
following example:
The physical location has the following form:
U787A.001. AAAXXXX -P3-D4
where
P3-D4
is the position
of the disk drive or solid-state drive in the system unit or an expansion unit. You can get the
U787A.001. AAAXXXX
location information from the control panel display on the system unit or
expansion unit.
If you cannot get the information from the control panel, find the feature code (FC) and sequence
number (SN or SEQ) on the label that is on the front of the system unit or an expansion unit as
shown in the following figure.
In this example,
U787A.001.AAAXXXX-P3-D4
, U787A.001 comes from the feature code (FC) on the label,
AAAXXXX comes from the last 7 digits of the sequence number (SN or SEQ) on the label, and
P3–D4 is the slot where you are replacing the disk drive or solid-state drive.
In the example,
U5074.001. AAAXXXX -DB3-D32
, you would replace a disk drive or solid-state drive in
the expansion unit with type 5074, model 001, sequence number AAAXXXX , and disk drive or
solid-state drive position DB3–D32.
9.
Select
1
(Remove device) for the
Action to be performed
.
10. Set the time delay, for example, for one minute:
01
.
Note: You can set an appropriate time delay of 01 - 19 minutes to allow adequate time to access the
disk drive or solid-state drive.
Important: Do not press Enter at this time.
11. Locate the service indicator that corresponds to the position of the drive that you are removing from
a system or from an expansion unit.
Choose from the following options:
v If you are removing a drive from a system, proceed to “Removing the disk drive or solid-state drive
from the 8248-L4T, 8408-E8D, or 9109-RMD system or expansion unit.”
v
If you are removing a drive from the EDR1 PCIe storage enclosure, proceed to “Removing a solid-state
drive from the EDR1 PCIe storage enclosure” on page 45.
Removing the disk drive or solid-state drive from the 8248-L4T,
8408-E8D, or 9109-RMD system or expansion unit
Complete the following steps to remove a disk drive or solid-state drive from a system or from an
expansion unit:
1. On the system, unlock the drive handle by squeezing it and pulling it out toward you, as shown in
Figure 28 on page 44.
2. On the console, select the drive that you want to remove and press Enter. To view the locations of the
service indicators, go to “Disk drives or solid-state drives locations and service indicators” on page 89.
Important:
Figure 27. Example system or expansion unit label
Removing a disk drive or solid-state
43