IBM 8248-L4T, Руководство пользователя

Страница: 26 / 214

7.
On the console, press Enter to indicate that you have installed the drive.
Proceed to the procedure for completing the disk drive or solid-state drive installation. For instructions,
go to “Completing the disk drive or solid-state drive installation by using the diagnostic command.”
Completing the disk drive or solid-state drive installation by using the
diagnostic command
Complete the following steps after you install or replace the disk drive or solid-state drive in a system or
in an expansion unit:
1. Complete the following steps by using the diagnostic command:
a. Press Enter.
b.
Exit to the command line.
c. If you are installing more than one disk drive or solid-state drive, repeat this procedure until all
disk drives or solid-state drives are installed.
d. Press Cancel. The SCSI and SCSI RAID Hot Plug Manager menu is displayed.
e. Select Configure Added/Replaced Devices .
2. Proceed to completing the procedure.
Completing the procedure
Complete the following steps after you install or replace the disk drive or solid-state drive in a system,
enclosure, or expansion unit:
1.
Replace the front cover. For instructions, see “Installing the front cover on the 8248-L4T, 8408-E8D, or
9109-RMD” on page 147.
2. Verify the installed part:
v
If you replaced the part because of a failure, verify the installed part. For instructions, see
“Verifying a repair” on page 161.
Figure 3. Installing a solid-state drive in the EDR1 PCIe storage enclosure
10
Disk drives or solid-state drives