IBM 8248-L4T, Руководство пользователя

Страница: 49 / 214

If you are removing a drive as part of a service procedure, continue to use the following procedure.
Note: Some of the figures in these procedures might not look exactly like the system or expansion unit
that you have. However, the steps to complete the task are the same.
Complete the following tasks to remove a drive:
v
“Preparing to remove a disk drive or solid-state drive”
v “Preparing to remove the disk drive or solid-state drive by using the iprconfig command”
v
Select from the following options:
– “Removing the disk drive or solid-state drive from the 8248-L4T, 8408-E8D, or 9109-RMD system or
expansion unit” on page 38
– “Removing a solid-state drive from the EDR1 PCIe storage enclosure” on page 39
Related information :
Removing and replacing a disk drive in the 5887 disk drive enclosure unit
Preparing to remove a disk drive or solid-state drive
Complete the following steps before removing a disk drive or solid-state drive from a system or from an
expansion unit:
1. Complete the prerequisite tasks. For instructions, see “Before you begin” on page 129.
2. If applicable, remove the system unit door or expansion unit door or open the rack front door.
Proceed to the procedure for removing the disk drive or solid-state drive by using the iprconfig
command.
Preparing to remove the disk drive or solid-state drive by using the
iprconfig command
Complete the following steps to remove a disk drive or solid-state drive from a system or from an
expansion unit by using the iprconfig command:
1. Log in as root user.
2. Type
iprconfig
on the command line of the Linux session and press Enter.
The IBM Power RAID Configuration Utility display is shown.
3. Select Analyze log . Press Enter. The Kernel Messages Log display is shown.
Removing a disk drive or solid-state
33