IBM 8248-L4T, Руководство пользователя

Страница: 36 / 214

2. If the drive you are installing does not have a bezel preinstalled, then complete the tasks to install a
bezel on the drive, then continue with this procedure from step 3. For instructions to install a bezel,
see “Installing a disk drive bezel in a disk drive or filler” on page 80.
3.
Unlock the drive handle (A) by squeezing it and pulling it out toward you. If the handle is not all
the way out, the drive does not slide into the system or expansion unit.
4. Hold the drive by the top and bottom edges as you position the drive, and insert it into the system
or the expansion unit.
Note: Do not hold the drive only by the handle. Support the drive by holding the drive by its sides.
5. Slide the drive halfway into the system or expansion unit.
6.
In the HSM display, select the drive that you want to install.
7. Press Enter on the console.
Important: When you press Enter, after your selected time delay, the service indicator light comes on
(solid) for 18 seconds. You then have 18 seconds to slide the drive all the way in and then lock it in
place by pushing in the drive handle. You can set an appropriate time delay of 01 - 19 minutes to
allow adequate time to access the disk drive or solid-state drive.
8. When the identify LED turns on solid, slide the drive all the way into the system or an expansion
unit, and push the drive handle
(A) in until it locks, as shown in Figure 11.
9. On the console, press Enter to indicate that you have installed the drive.
10. If you are installing more than one disk drive or solid-state drive, repeat the steps in this procedure
until all disk drives or solid-state drives are installed.
Proceed to the procedure for completing the disk drive or solid-state drive installation. For instructions,
go to “Completing the disk drive or solid-state drive installation” on page 22.
Figure 11. Installing the disk drive in the system
20
Disk drives or solid-state drives