IBM 8248-L4T, Руководство пользователя

Страница: 96 / 214

3. Retain the removed disk drive bezel safely and use the removed bezel to attach it to the replacement
disk drive or a disk drive filler.
Return to the procedure that brought you here.
Installing a disk drive bezel in a disk drive or filler
Learn how to install a disk drive bezel into a disk drive.
You must have removed the disk drive bezel from either a failed disk drive that had a bezel installed in
it or from the disk drive filler. To remove a disk drive filler, see “Removing a disk drive bezel from a disk
drive or filler” on page 79. Perform the steps in this procedure only if the disk drive or the disk drive
filler removed had a disk drive bezel attached to it.
Note: If the disk drive bezel does not have a thumbscrew, it is not removable and is a SAS disk drive.
The replacement SAS disk drive comes with an attached bezel.
1. Attach the disk drive bezel (A) to the disk drive or to a disk drive filler.
Attention:
v
Attach a wrist strap to an unpainted metal surface of your hardware to prevent electrostatic
discharge (ESD) from damaging your hardware.
v
When using a wrist strap, follow all electrical safety procedures. A wrist strap is for static control. It
does not increase or decrease your risk of receiving electric shock when using or working on
electrical equipment.
v
If you do not have a wrist strap, just prior to removing the product from ESD packaging and
installing or replacing hardware, touch an unpainted metal surface of the system for a minimum of
5 seconds.
2. Press in and then tighten the thumbscrew (B) to secure the bezel to the disk drive or filler.
Figure 48. Removing a disk drive bezel
80
Disk drives or solid-state drives