IBM 8248-L4T, Руководство пользователя, Страница: 41 / 214

6.
If you are installing more than one disk drive or solid-state drive, repeat the steps in this procedure
until all disk drives or solid-state drives are installed.
Proceed to the procedure for completing the disk drive or solid-state drive installation. For instructions,
go to “Completing the procedure” on page 27.
Installing a disk drive or solid-state drive in the 5887 disk drive
enclosure
Complete the following steps to install a disk drive or solid-state drive in the 5887 disk drive enclosure:
1. With the handle in the unlocked position, as shown in Figure 15 on page 26, support the bottom of
the drive as you align it with the guide rails in the expansion unit.
Note: Do not hold the solid-state drive only by the handle. Support the drive by holding the drive by
its sides.
2. Slide the drive into the 5887 disk drive enclosure until the drive stops.
Important: When installing a drive, ensure that the drive is fully seated and is all the way into the
enclosure.
3. Rotate the handle to the locked position.
Figure 14. Installing the disk drive in the system
Installing a disk drive or solid-state drive
25