IBM 8248-L4T, Руководство пользователя

Страница: 88 / 214

Note: Do not hold the drive only by the handle. Support the drive by holding the drive by its sides.
2.
Slide the solid-state drive into the EDR1 PCIe storage enclosure until the drive stops.
3. Rotate the handle (A) to the locked position, as shown in Figure 44.
4. Install the bezel (B) .
Proceed to the procedure for completing the disk drive or solid-state drive replacement. For instructions,
see “Completing the procedure.”
Completing the procedure
Complete the following steps after you install or replace the disk drive or solid-state drive in a system,
enclosure, or expansion unit:
1. Replace the front cover. For instructions, see “Installing the front cover on the 8248-L4T, 8408-E8D, or
9109-RMD” on page 147.
2. Start the system or logical partition. For instructions, see “Starting the system or logical partition” on
page 139.
3.
Verify the installed part:
v
If you replaced the part because of a failure, verify the installed part. For instructions, see
“Verifying a repair” on page 161.
v
If you installed the part for any other reason, verify the installed part. For instructions, see
“Verifying the installed part” on page 149.
4. To configure the newly installed disk drive or solid-state drive, see the following procedures for the
applicable operating system that controls the disk drive or solid-state drive:
v
“Preparing a disk drive or solid-state drive for use in an AIX system or logical partition” on page
97.
v
“Configuring a disk drive or solid-state drive in an IBM i system or logical partition” on page 104.
Figure 44. Replacing a solid-state drive in the EDR1 PCIe storage enclosure.
72
Disk drives or solid-state drives