horsch LEEB PT 330, Руководство по эксплуатации

Страница: 22 / 203

1.6.12 Working implements
¾
Attention! After switching of the drives there
is still a danger caused by the coasting down
gyrating mass! Do not step close to the ma-
chine during this phase. Work on the machine
may only be started once the machine is fully
at standstill.
¾
Cleaning, lubrication and adjustment work on
the working implements must only be carried
out with drive and engine shut down and the
ignition key pulled out!
1.6.13 Crop protection sprayer
operation
¾
Please pay attention to the recommendations
of the crop protection product manufacturer
concerning protective clothing, warning notes
for the handling of crop protection agents
and the metering, application and cleaning
instructions.
¾
Pay attention to the notes in the Plant Protec-
tion Act!
¾
Never open pressurized lines!
¾
Use only original spare hoses from HORSCH
LEEB AS, which will withstand the chemical,
mechanical and thermal loads. For assembly
you should generally use hose clamps made
of V2A! Repair work inside the spraying mix-
ture container must only be performed after
thorough cleaning and with a respirator. This
work must be monitored by a second person
outside the spraying mixture container for
safety reasons!
¾
Please pay attention to the following when
repairing crop protection sprayers, which have
been used with ammonium nitrate - carbonyl
diamide solution: by the evaporation of water,
residues of ammonium nitrate - carbonyl di-
amide solution can be form salt on or inside the
spraying mixture container. This results in pure
ammonium nitrate and carbonyl diamide. In its
pure form, ammonium nitrate in connection
with organic matter, such as carbonyl diamide,
becomes explosive, if critical temperatures
(caused by e.g. welding work, grinding, filing)
are reached during repair work.
¾
By thorough washing off the spraying mixture
container or the parts to be repaired with
water, this endangerment can be eliminated,
because the salt of the ammonium nitrate -
carbonyl diamide solution is water soluble.
Therefore always clean the crop protection
sprayer thoroughly with water before starting
repair work!
¾
The rated volume of the spraying mixture
container must not be exceeded when filling!
¾
At the headland reduce the travel speed and
switch off the sprayer.
¾
Excessive, jerky steering movements at
the beginning and the end of a curve will
put extreme loads on the folding boom.
¾
When applying small droplets under strong
wind, the chemical can be blown about and
thus cause damage for others!
¾
If the soil is very dry, the applied chemical
can be blown away together with dust and
cause damage. Always wait until the soil is
sufficiently moist!
¾
Check the following from time to time: Meter-
ing quantity, clogged nozzles, damage to
machine parts, leakage and cleanliness of
the machine.
¾
Always wear appropriate protective clothing
(gloves, suit, safety goggles, etc.) when han-
dling crop protection agents!
¾
For cabins with ventilation fans replace the
fresh air filters with activated-carbon filters!
¾
Observe the data on compatibility of crop
protection agents with materials of the crop
protection sprayer!
¾
Do not spray any crop protection agents that
have a tendency to agglutination or solidification!
¾
Do not fill crop protection sprayers with water
from open waterbodies - to protect man, ani-
mal and environment!
¾
Always ensure a sufficient water supply in the
machine to be able to wash off crop protection
agent in events of emergency.
¾
When using these products strictly comply
with the instructions for use and the precau-
tions listed issued by the crop protection
product manufacturer!
22