Honeywell Vocollect, Справочник по аппаратуре

Страница: 195 / 316

| Honeywell Wireless Headsets | 195
Desired Action Button Press Action Valid In These SRX-SL
States
Power On Power button Press and hold for at least
½ second
Off
Power Off Power button 5 seconds All except Off
Volume Up Volume Up button Momentary All except Off
Volume Down Volume Down button Momentary All except Off
Start voice recognition
application on the
connected device
Power button 1 second On, paired and connected,
no active call, voice
application, or A2DP
stream,
Disconnect, cleared paired
devices, enter pairing mode
Volume Up and Volume
Down buttons
Momentary All except Off
Answer call Power button Momentary Incoming call
Reject call Power button 1 second Incoming call
Hang up call Power button Momentary Active call
Transfer audio Power button 1 second Active call
Mute/Unmute microphone Mute button, Momentary press, or rotate
the boom up 90° to mute,
rotate the boom down 90°
to unmute
Active call or voice
application
Connect to last device Power button Momentary On and paired, but not
connected
Reset headset (restarts the
headset in the rare event
the SRX-SL headset has
become unresponsive)
Power and Mute buttons 5 second All except Off
LED and Tones
The SRX-SL contains a single LED that signals events to the user. The LED is accompanied by tones to signal these
events when the headset is being worn.
Use Case SRX-SL State LED Tones
Pairing mode, default state
at power up.
Discoverable and
Connectable.
Solid green High-pitch double beep at
power up
Powering off Off Solid green for 1 second
then all off.
Low-pitch double beep
atpower off
Normal operation Paired and connected.
Flashing blue.
Flash frequency is 1.5
seconds
On 20%, off 80%.
Three ascending tones on
connect
Pairing Failure Discoverable and
Connectable
Solid Green Long low-pitch tone