Honeywell Vocollect, Справочник по аппаратуре

Страница: 208 / 316

| Honeywell Wireless Headsets | 208
Option Description
(ring) indicator blinks green. Note that there is a
30-second timeout after a headband is recognized
in step one. You must pair the electronics module
within 30 seconds from associating the headband
for full functionality.
Note: If the device state indicator blinks red, the NFC read was not successful, and you should attempt to
perform the read again .
Option Description
If you are not sharing headsets at your site:
You only need to pair the device to the SRX2
electronics module:
1.
Touch the side of the A700 device that has the
symbol and the oval area of the SRX2's keypad
section together, aligning the ovals on each and
holding them together steadily, until the device state
(ring) indicator blinks green.
Note: If the device state indicator blinks red, the NFC read was not successful, and you should attempt to
perform the read again.
Figure 147: Using TouchConnect to Obtain
Operator Information from the Headband
Figure 148: Using TouchConnect to Pair an
SRX2 with an A700 Device
When the device starts the task, VoiceConsole recognizes the pairing.
Auto Pairing an SRX2 Headset with a T5, A500, or A700 Talkman Device
Prerequisites:
• The headset is powered off.
• There is no wired headset connected to the Talkman device.
• The Talkman device is Bluetooth ready with Bluetooth connection features enabled.
Important: An unpaired device will constantly search for wireless headsets while in auto pairing mode. Do
not leave an auto pair-enabled device unpaired and powered on because the search will drain the battery.
1. Reboot the Talkman device or remove it from a charger to initiate a scan for headsets.
2.
Turn on the headset.
The headset will remain in pairing mode for ten minutes. If not paired within ten minutes, it powers off.
3. Hold the headset and Talkman device so they are within six inches of each other but not touching.