Honeywell Vocollect, Справочник по аппаратуре

Страница: 117 / 316

| Talkman T5 Series | 117
are not mounted in an approved manner. Please note that not mounting Talkman devices in an approved
manner may also violate local safety laws and possible cause a safety hazard by damaging Talkman devices
and batteries.
Follow these steps to install a mounting bracket.
1. Drill the holes required to secure the base to the vehicle. If using the clamp mount, skip this step.
2.
Screw or clamp a base to the location.
Tip:
Apply some lubricant (for example, light oil or anti-sieze) to the threads of the clamp mount screws.
3. Attach the other base to the other end of the arm and tighten once in the desired location by turning the locking
lever clockwise.
4. Screw the device holder to the base.
Important: To prevent vibration, the arm of the mounting bracket should not touch the stem of the ball of the
base. In other words, the arm should not be tilted so far that these pieces touch.
Connecting Cables to the Power Supply and Attaching the Power Supply to a Vehicle
The following parts are supplied by Honeywell for attaching the 12 or 24 volt vehicle's power supply to a device:
Item # Quantity Description
1 1 Power Supply, 9-36 VDC Input
2 1 Cable from power supply to battery
adapter
The following parts are supplied by Honeywell for attaching the 36 or 48 volt vehicle's power supply to a device:
Item # Quantity Description
1 1 Power Supply, 18-60 VDC Input
2 1 Cable from power supply to battery
adapter
You will need the following equipment:
• One Cable from the power supply to vehicle’s power source. Honeywell recommends an industrial rated cable
with the following specifications: Number of conductors = 3, Gauge of wire = 16, Temperature = -40C to 90C
• Cable ties
CAUTION:
General Guidelines for Routing Electrical Cables
• The vehicle must be off and the vehicle's battery must be disconnected.
• Cables should be kept clear of surfaces that may become hot.
• Cables should not be run such that they can get caught on moving parts.
• Cables should not be run on the outside of a vehicle.