Honeywell Vocollect, Справочник по аппаратуре

Страница: 84 / 316

| Talkman A500 | 84
CAUTION: Do not attempt to place the device into the charger unless you have first disconnected the
headset and any other peripheral devices. Do not remove the battery from the device when placing a device
into a charger.
Charging an A500 or T5-Series Battery
1.
Remove the battery from the Talkman device.
2. Hold the battery with its contacts to the bottom and the Vocollect label facing you.
Figure 25: Inserting a Battery Into the Charger
3. Place the battery into an open battery slot on the top level of the charger.
When the battery is placed into the charger properly, the left LED indicator for the slot into which the battery was
placed turns red.
Note: The upper set of LED indicators apply to the charger's battery slots and the lower indicators apply
to the devices' slots.
Removing an A500, T2-Series or T5-Series Device From a Charger
The device is ready to use when the LED indicator on the device is blinking green. If the LED is blinking red, the
device is not ready to be used.
Important:
If a device continuously displays a solid red light, contact your system administrator.
1. Make sure that the device is ready to use.
2. Pull up on the device to remove it from the device charger.
Figure 26: Removing a Device from a Charger
Inserting a Battery into a Talkman A500, T5-Series or T2-Series Device
Make sure the battery to be inserted is fully charged.
1. Hold the Talkman so that the red and yellow ports are facing away from you.
2.
Hold the battery with the pins facing away from you and so that the Vocollect logo is on top.
3. Place the battery in at an angle, pins end first.