Honeywell Vocollect, Справочник по аппаратуре

Страница: 23 / 316

| Talkman Devices and Headsets | 23
Turning a Talkman Device On
Before you turn on a device, make sure a headset and charged battery are properly connected to it.
1.
Press the Play/Pause button on the device.
The LED indicator differs depending on the device being used.
Device Type Indicator
A700 series The ring is yellow and rotates, then the ring segment
turns solid green.
T2 series, T5 series and A500 First turns solid red while the processor reboots. It then
flashes red and green, turns solid, blinks red, then turns
solid green.
T1 Turns solid green
2. The device says, "Current operator is operator name . Please keep quiet for a few seconds." The device then starts
a noise sample.
3.
After a brief pause, it says, "Please wait." After another pause, the device begins asking questions or providing
instructions.
Turning a Talkman Device Off
Use a button control to properly power off the Talkman device. In some cases, the device turns off automatically. In
rare cases, a forced reset may be necessary. After the device is fully turned off, you can reboot it.
Powering Off by Using the Play/Pause Button
Press and hold the Play/Pause button until the LED indicator turns red. The device will store any data that has not
been transmitted. After a few seconds, the device says, "Powering off." The device turns off, and the LED indicator
light goes out.
CAUTION:
• Do not remove the battery until the LED indicator is off. If you remove the battery when the device is on
or sleeping, any data collected could be lost.
• You should not turn off the device if the LED indicator is blinking red (A500, T5-series and T2-series)
or has a rotating red ring (A700), unless it has been blinking red or rotating red for several minutes. If a
device is turned off in this state, it may not be ready to use when it is turned back on.
Powering Off Due to Inactivity
If the device's software detects no device activity for a specified length of time, it powers off automatically.
Powering Off Due to Low Battery Levels
If the device's software detects that the current battery level is critically low, it powers off automatically.
Booting a Device After Powering Off
If a device was properly powered off, it does the following operations after a battery is placed into the device and the
Play/Pause button is pressed:
• Performs a background noise sample
• Continues operation at the place in the task where you left off
• Transfers any templates to the host that had not been sent prior to powering off